Wing Reinforcement Lamination - Sawn Craft Micro Gloster Javelin Assembly And Setup Manual

Sawn Craft Micro Javelin Manual

2.3 Wing Reinforcement Lamination

•
Parts Required:
o Main Wing
o KFm Step
1) Lay the main wing on the table with the milled brick location markings slot facing up. Apply a bead
of glue around the entire perimeter of the KFm Step.
2) Press the glued side of the KFm onto the Main Wing, aligning the leading edges of both parts, and
gently slide the parts around to spread the glue evenly.
3) Set the assembled fuse lamination aside to allow the glue to cure. If desired you can place a flat
weight (book, etc.) on top of the lamination while curing to ensure a flat assembly.
4) Once cured, sand leading edges to your liking.
Page 6 151120 Micro Javelin Manual.docx