Assigning Parameters To The Analog Inputs / Outputs - Siemens SINUMERIK ONE NCU 1760 Equipment Manual

Terminal Byte
n+4
X333
n+5
Table 11-56 Output image of analog outputs for the 1st I/O module (m=56)
Byte
m+0
m+1
m+2
m+3
m+4
m+5
m+6
m+7
11.3.5.2

Assigning parameters to the analog inputs / outputs

Operating mode
Parameters are assigned to the operating mode via the m+0 byte (Analog Control Byte 0) of the
output image of the analog outputs:
Byte
m+0
m+1
m+2
m+3
The reserved bits must be preassigned with the value "0".
The operating mode is set to "no operating mode" during ramp-up, as soon as a valid setting
is made this will be applied and will subsequently no longer be reset. If a reset is initiated by the
user, this is interpreted as an error.
NCU 1760
Equipment Manual, 02/2020, A5E45627861B AB
Bit7 Bit6 Bit5
Pin38 Pin37 Pin36
DO 4.7 DO 4.6 DO 4.5
Pin46 Pin45 Pin44
DO 5.7 DO 5.6 DO 5.5
Bit7 Bit6
AO 0.15 AO 0.14
AO 0.7 AO 0.6
AO 1.15 AO 1.14
AO 1.7 AO 1.6
Bit7 Bit6
AO AO
(channel (channel
4) 4)
Bit4 Bit3
Pin35 Pin34
DO 4.4 DO 4.3
Pin43 Pin42
DO 5.4 DO 5.3
Bit5 Bit4 Bit3
Analog Control Byte 0
Analog Control Byte 1
Analog Control Byte 2
Analog Control Byte 3
AO 0.13 AO 0.12 AO 0.11
AO 0.5 AO 0.4 AO 0.3
AO 1.13 AO 1.12 AO 1.11
AO 1.5 AO 1.4 AO 1.3
Bit5 Bit4 Bit3
AO AO AI
(channel (channel (channel
3) 3) 2)
Reserved
Reserved
Reserved
Connectable components
11.3 PP 72/48D PN 2/2A PN
Bit2 Bit1 Bit0
Pin33 Pin32 Pin31
DO 4.2 DO 4.1 DO 4.0
Pin41 Pin40 Pin39
DO 5.2 DO 5.1 DO 5.0
Bit3 Bit1
AO 0.10 AO 0.9
AO 0.2 AO 0.1
AO 1.10 AO 1.9
AO 1.2 AO 1.1
Bit3 Bit1
AI AI
(channel (channel
2) 1)
Bit0
AO 0.8
AO 0.0
AO 1.8
AO 1.0
Bit0
AI
(channel
1)
Data for‐
mat
143