Siemens SINUMERIK ONE NCU 1760 Equipment Manual page 136

Connectable components
11.3 PP 72/48D PN 2/2A PN
Digital inputs
Low-level voltage (U
Signal delay time T
Signal delay time T
3.7)
Digital outputs
● Characteristics
– No galvanic isolation.
– Protection against: Short-circuit, overtemperature, and loss of ground.
– Automatic disconnection in case of undervoltage.
● Terminal assignment for the digital outputs:
The following figure shows an example of the terminal assignment for the digital outputs on
connector X111. Connectors X222 and X333 are assigned analogously.
Figure 11-16
● Technical data:
136
)
L
PHL
rapid inputs (X222: DI 3.0 to
PHL
:
:
:
:
Terminal assignment for the digital outputs
NOTICE
Damage to the module
If the outputs are overloaded, the heat can melt the contacts.
Therefore, for a demand factor of 100%, a max. current of I
Pin 2, must not be exceeded.
min.
-3 V
0.5 ms
-
1
(M)
Equipment Manual, 02/2020, A5E45627861B AB
max. Nominal
5 V 0 V
3 ms -
- 600 μs
= 0.25 A at X111, X222, X333:
out
NCU 1760