Troubleshooting; Introduction - Troubleshooting; Fault Messages - Flymo EasiLife 200 Operator's Manual

6.1 Introduction - troubleshooting

In this chapter, faults and symptoms are described and can guide you if the product does not operate
as expected. More suggestions for steps to take in the event of malfunction or symptoms can be found
on www.flymo.com/uk.
6.1.1 To get access to the Quick info menu
Technical data, values and information about the
history of the product can be found in the
info menu. If you speak to Flymo central service
for a solution to a problem, they can tell you to

6.2 Fault messages

The fault messages in the table below are shown in the display of the product. Speak to your Flymo
customer service if the same message shows frequently.
Message Cause
Cutting system
Grass or other object has wrapped
blocked
around the blade disc.
The blade disc lies in a pool of water.
The grass is too high.
Outside working
The boundary wire connections to the
area
charging station are crossed.
The boundary wire is too close to the
edge of the work area.
The work area slopes too much by the
boundary loop.
The boundary wire is laid in the wrong
direction around an island.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
The product finds it hard to distinguish
the signal from another product installa-
tion close by.
1392 - 001 -

6 Troubleshooting

access the information that is available in this
menu.
Quick
• Push the Menu button for 3 seconds to enter
Quick info menu.
the
Action
Check the blade disc and remove the
grass or other object.
Move the product and prevent the col-
lection of water in the work area.
Cut the grass before you install the
product. Make sure that the grass is
maximum 4 cm / 1.6 in.
Check that the boundary wire is con-
nected correctly.
Check that the boundary wire has been
laid according to the instructions. Refer
to
21 .
Try moving the boundary wire.
Place the product in the charging sta-
tion and generate a new loop signal.
To install the boundary wire on page
Troubleshooting - 39