60- cm / 24- in.
•
Put the charging station near a power outlet.
•
Put the charging station on a level surface.
Max 5 cm/2"
Max 5 cm/2"
Max +/- 2 cm / 0.8 in.
•
Put the charging station in the lower section
of the work area.
•
Put the charging station in an area with
protection from the sun.
•
If the charging station is installed on an
island, make sure to connect the guide wire
to the island. Refer to
page 17 .
1392 - 001 -
To make an island on
3.4.2 To examine where to put the power
supply
WARNING: Do not cut or extend the
low-voltage cable. There is a risk of
electrical shock.
CAUTION: Make sure that the blades
on the product do not cut the low-
voltage cable.
CAUTION: Do not put the low-voltage
cable in a coil or below the charging
station plate. The coil causes
interference with the signal from the
charging station.
•
Put the power supply in an area with a roof
and protection from the sun and rain.
•
Put the power supply in an area with good
airflow.
•
Use a residual-current device (RCD) when
you connect the power supply to the power
outlet.
Low-voltage cables of different lengths are
available as accessories.
Installation - 15