Troubleshooting; Introduction - Troubleshooting; Fault Messages - Flymo EasiLife Operator's Manual

6.1 Introduction - troubleshooting

In this chapter you can find information and help about faults and symptoms of the product. You can find more
information and FAQ (Frequently Asked Questions) on www.flymo.com/uk.
6.1.1 To get access to the Quick info menu
Technical data, values and information about the history
of the product can be found in the
you speak to Flymo central service for a solution to a

6.2 Fault messages

The fault messages in the table below are shown in the display of the product. Speak to your Flymo representative if
the same message shows frequently.
Message Cause
Wheel motor
Grass or other object around the drive wheel. Remove grass or other object.
blocked, left/right
Cutting system Grass or other object around the blade disc.
blocked
The blade disc is in water.
The grass is too high.
Trapped
The product is behind a number of obstacles
in a small area.
Outside working area A section of boundary wire is put across the
other section of boundary wire to the charg-
ing station.
The boundary wire is too near the edge of
the work area.
The work area slopes much by the boundary
loop.
The boundary wire is put in the incorrect di-
rection around an island.
Interference to the boundary wire from metal
objects such as fences, reinforcement steel
or buried cables nearby.
The product cannot find the correct loop sig-
nal because of interference with a loop signal
from a different product installation nearby.

34 - Troubleshooting

6 Troubleshooting
problem, they can tell you to access the information that
is available in this menu.
•
Quick info menu. If
Push the Menu button for 3 seconds to enter the
Quick info menu.
Action
Remove grass or other object.
Move the product and prevent the collection
of water in the work area.
Cut the grass before you install the product.
Make sure that the grass is maximum 4 cm /
1.6 in.
Remove the obstacles or put the boundary
wire around the obstacle to make an island.
Refer to To make an island on page 16 .
Make sure that the boundary wire is connec-
ted correctly.
Make sure that the boundary wire is installed
To install the boundary
correctly. Refer to
wire on page 19 .
Move the boundary wire.
Put the product in the charging station and
generate a new loop signal.
1392 - 007 -