Replace The Blades; Battery - Flymo EasiLife 200 Operator's Manual

5.2.4 Charging station
WARNING: Use the plug to disconnect
the charging station before any
maintenance, or cleaning of charging
station or power supply.
Clean the charging station regularly from grass,
leaves, twigs and other objects that may impede
docking.

5.3 Replace the blades

WARNING: Use blades and screws of
the right type. Flymo can only
guarantee safety when using original
blades. Only replacing the blades and
reusing the screw can result in a screw
wearing during mowing. The blades
can then be propelled from under the
body and cause serious injury.
Replace worn or damaged parts for safety
reasons. Even if the blades are intact, they
should be replaced on a regular basis for the best
mowing result and low energy usage. All 3 blades
and screws must be replaced at the same time to
obtain a balanced cutting system. Use Flymo
original blades embossed with the crowned H-
Warranty on page 53 .
mark logotype, refer to
5.3.1 To replace the blades
1. Push the STOP button.
2. Open the hatch.
3. Push the ON/OFF button for 3 seconds to
switch off the product.
36 - Maintenance
4. Check that the indicator lamp on the keypad
is not lit.
5. Turn the product upside down. Place the
product on a soft and clean surface to avoid
scratching the body and the hatch.
6. Remove the 3 screws. Use a straight slot or
cross-tip screwdriver.
7. Remove each blade and screw.
8. Fasten new blades and screws.
9. Check that the blades can pivot freely.

5.4 Battery

WARNING: Only charge the product
using a charging station which is
intended for it. Incorrect use may result
in electric shock, overheating or
leakage of corrosive liquid from the
battery. In the event of leakage of
electrolyte flush with water and seek
medical help if it comes in contact with
the eyes etc.
1392 - 001 -