NAMCO TEKKEN TAG TOURNAMENT Operation Manual page 39

JVS CABINET OPTIONS
<DEFAULTS
. . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . .
: Pl -START
E X I T
2
Hit the Pi S-direction joystick to right.
Each time it is hit, the synchronizing signal output type of the video output, which is displayed
under "VIDEO SYNC" (shown as (a) in the above figure), shall be switched to change the
setting. (The type shown in the thick frame below is the default setting.)
Note: The above figure shows the pair control panel. In case of the single control panel
(that is, two cabinets corresponding to the JAMMA
linked for networked head-@head play), the control panel of the cabinet on which
the PC board is installed shall he called as Pl.
Composite
(composite
SYNC" as "Separate" for the best picture.
l Namco-made CYBERLEAD cabinet corresponds to the separate signal. But if
another monitor display is connected to the line output picture terminal on the back
of the cabinet, set the "VIDEO SYNC" as "Composite", because that monitor
display may get poor picture under the "Separate" setting.
3 Press the PI start switch to return to the test menu screen.
Note: The above figure shows the pair control panel. In case of the single control panel
(that is, two cabinets corresponding to the JAMMA
linked for networked head-tehead
the PC board is installed shall be called as PI.
IN GREEN>
[STEP 11
joystick
Synchronizing signal output type of the video output
(vertical synchmnizationfnorizonral
synchronization)
PI start switch
play), the control panel of the cabinet on which
Display on the JAMMA
J
VIDEO standard (JVS) are
Separate
synchronization)
VIDEO standard (JVS) are
VIDEO