NAMCO TEKKEN TAG TOURNAMENT Operation Manual page 18

4 Connect the wires of the extended edge harness on the following table to the terminals of PI
button switch 4,5,6 and P2 button switch 4,5,6 on the control panel by soldering or fixing an
applicable crimp-style terminal.
Soldered side
P2 button switch 4 (white/blue)
electrical shock. Contact your distributor to order parts. Refer to "11. REPLACEMENTPARTS
LIST,' on p.56 for details of the replacement parts.
Apply insulating heat contraction tube on the connecting part to
circuit.
terminal number A8,A9, AZO,BS,Bl3,B19) of the extended edge harness should
be connected to the N.O. terminal of the button switch. GND of the extended
edge harness (wires with the terminal number B9, BlO) should be connected to
the COM terminal of the button switch.
In case the button switch is two-terminal, these can be connected to either
terminal.
5 Install the control panel on the cabinet.
Terminal side
A 8
B 1 3
Parts mounted side
P2 button switch 5 (white/purple)
GND (black)
GND (black)
switch 45.6
\
Extended edge harness
prevent short-