NAMCO TEKKEN TAG TOURNAMENT Operation Manual page 16

2 Check the power source for the cabinet connecting to the JAMMA edge connector and voltage
of the power source for the coin counter of the cabinet.
l
The power source on the cabinet connected to the JAMMA edge connector should fit the following
requirements:
If the power source does not conform to this requirement, it may cause a fire.
5-3-2 Checking the Extended Edge Connector @B
To connect this product to the cabinet corresponding to the JAMMA standard, use the extended
edge connector attached to this product.
Check if the terminal numbers of the extended edge connector conform to the following table.
* The extended edge connector shall not be used when installing the product to the cabinet
corresponding to the JAMMA VIDEO standard (JVS).
PI button switch 4 (blue)
Voltage of the power source for the coin counter of the cabinet should be +12V or
board may break down.
Extended Edge Connector (48P 2.54 mm pitch)
A 1 6
A 1 7
A 1 9
A 2 0
A 2 2
A 2 3
A 2 4
B 2 0
B 2 2
B 2 3
B 2 4