Installing Module Spacer (Generac Pwrcell 3 And Generac Pwrcell 5 Only); Installing Retention Clips - Generac Power Systems PWRcell 3 Installation Manual

Installing Generac PWRcell Battery
Installing Module Spacer (Generac PWRcell 3
and Generac PWRcell 5 only)
See Figure 4-15. Module spacers (O) must be installed
on any single module shelf.
Figure 4-15. Module Spacer
Generac PWRcell modules and upgrade kits can be
obtained by contacting Generac Customer Service at 1-
888-436-3722 (1-888-GENERAC),
erac.com.
NOTE: Kits must be installed by a qualified individual.
See Table 5: Module Spacer Kit
Table 5 – Module Spacer Kit
Module Spacer Kit
Generac PWRcell Spacer Kit
To install module spacer:
See Figure 4-16. Angle top of spacer (P) under
1.
and behind bracket lip (Q).
Q
P
Figure 4-16. Installing Module Spacer (1 of 3)
18
O
009933
or www.gen-
for part number.
Part Number
HMSK101
009934
See Figure 4-17. Slide spacer up between brackets.
2.
Push bottom of spacer in.
3.
1
2
Figure 4-17. Installing Module Spacer (2 of 3)
See Figure 4-18. Secure spacer with two M4X8
4.
machine screws.
Figure 4-18. Installing Module Spacer (3 of 3)

Installing Retention Clips

See Figure 4-19. All front battery modules must be
secured with retention clips (R).
R
Figure 4-19. Retention Clips (1 of 3)
Installation Manual for Generac PWRcell Battery
009935
009936
009937