Installation - Firecom 5000D Series Installation & Operation Manual

INSTALLATION

BEFORE INSTALLING the Firecom 5000D Series Intercoms, make sure you have read and understood the entire
installation procedure. You should also read the sections on Pre-Installation (page 7) and System Orientation (pages 3-5).
If any item in the Installation Procedure is not understood, or if you have any questions which are not addressed in this
manual, contact your local Firecom Dealer for more information BEFORE you proceed with the installation.
MOUNTING THE INTERCOM:
Using the mounting bracket as a template, mark the location of the mounting holes.
•
• Using a 3/16" drill bit, drill 2 holes for the #8 sheet metal screws (supplied).
• Be sure the area behind the panel you are drilling into is free of wires or other obstructions that
IMPORTANT:
could be damaged while drilling the holes
Install the mounting bracket with the sheet metal screws (Figure 8).
•
Remove the 4 screws (2 on each side) closest to the rear of the Intercom unit and mount the Intercom on the
•
mounting bracket with the 4 screws.
• DO NOT completely tighten the Intercom mounting hardware until the entire installation is
IMPORTANT:
complete.
MOUNTING THE HEADSET MODULES:
Using the Headset Module as a template (Figure 9), mark the location of the mounting holes. The holes in the
•
HM-10 used for mounting the module are marked with a letter "M".
• Using a 5/32" drill bit, drill 2 holes for the #6 sheet metal screws (supplied).
• IMPORTANT: Be sure the area behind the panel you are drilling into is free of wires or other obstructions that
could be damaged while drilling the holes.
Position the Headset Module and secure with the provided sheet metal screws.
•
FIGURE 8: The Mounting Bracket
13
Figure 9: Headset Modules