Service; Cleaning; Optical Accessories - GLP Fusion Par FP7 User Manual

www.glp.de

8. Service

Warning! There are no user-serviceable parts inside the Fusion FP7.
Opening the fixture can compromise its IP65 rating and cause damage
that is not covered by the product warranty. Any service operation that
requires removal of a cover must be performed by a GLP technician only.

Cleaning

The FP7 requires occasional cleaning to prevent the buildup of dust, dirt, residue from
atmospheric effects etc. Failure to keep a fixture clean will significantly reduce light
output and may cause damage that is not covered by the product warranty. Regular
cleaning will ensure maximum performance and reliable operation.
Inspect the fixture at regular intervals and clean it whenever dirt is visible. Pay special
attention to the cooling fins and the front of fixtures. You can clean the front of a
fixture using a soft cloth slightly dampened with a household or automotive glass
cleaning product. You can clean cooling fins with a soft brush and vacuum cleaner.
Do not immerse the fixture in water. Do not spray it with high-pressure water jets.

Optical accessories

A diffuser lens is available from GLP as an optional
accessory for the FP7. The diffuser gives a wider
beam angle and a softer beam. A quick-release
locking system on the front of FP7 fixtures lets you
install and remove the diffuser in seconds.
To install a diffuser on the front of the fixture:
See Figure 8. Pull the spring-loaded locking pin
A outwards, away from the center of the
fixture.
Insert one side of the diffuser behind the lip B in
the front of the fixture opposite the locking pin,
then insert the other side of the diffuser behind
the locking pin A.
Release the locking pin A so that it slides in
towards the center of the fixture under spring
pressure and holds the diffuser in place.
Check that the diffuser is held securely by the lip and the locking pin and cannot
fall out of the fixture.
To remove a diffuser, pull on locking pin A to release the diffuser, then lift the diffuser off
the front of the fixture.
26
Figure 8. Mounting points for
optical accessories
Fusion Par FP7 User Manual Rev. A
B
A