Information On The Display Panel - Siemens WD15G420HK Instruction Manual And Installation Instructions

Table of Contents

Advertisement

Faults and what to do about them
en
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with detergent
solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.
Wait until the drum has stopped turning.
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washer dryer door if
water can be seen through the glass.

Information on the display panel

Information
Õ
Hot
|
E:18
E:32
E:95
Other displays
42
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
Close the door, continue the programme with Start/Reload A button or
select Drain p programme.
Flashes slowly: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock cools down.
The door cannot be opened after the drying programme due to the high tempera-
ture. The cooling process continues until the display disappears, after which the
door can be opened.
Flashes (no water supply): Tap turned on? Water inlet filter blocked? Clean
the water inlet filter. ~ Page 41
Water hose kinked or blocked?
Lights up(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
Drain pump blocked; clean the drain pump. Clean the drainage hose on the siphon.
Alternating display with End when programme is finished: unbalance problem,
spinning phase is aborted.
Alternating display with End when programme is finished: no water detected in
drying phase, may get bad drying result.
Turn the programme selector to Off. The appliance is switched off. Wait 5 s and
switch on again. If the display is indicated again, call customer service.
Switch off the appliance. Disconnect
1.
the mains plug.
Drain the detergent solution
2.
Pull the emergency release
3.
downwards with a tool and release.
The washer dryer door can then be
opened.
.

Advertisement

Table of Contents
loading

Table of Contents