Table of Contents
Advertisement
@ Water drain hose
H Elbow for securing the water
drain hose*
P Water supply hose on standard/
Aqua-Secure models
*
depending on the model
In addition, a hose clamp (24 - 40 mm
diameter, available from specialist
dealers) is required to connect the
water drain hose to a siphon.
Useful tools
Spirit level for aligning
■
Spanner with:
■
– WAF13 for loosening the
transport braces, and
– WAF17 for aligning the appliance
feet
Safety instructions
:
Warning
Risk of injury!
The washer dryer is very heavy.
■
Be careful when lifting/transporting
the washer dryer.
When the washer dryer is lifted by its
■
protruding parts (e.g. the washer
dryer door), the components may
break off and cause injuries.
Do not lift the washer dryer by
protruding parts.
If the hose and mains cables are not
■
routed properly, there is a risk of
tripping and injury.
Lay hoses and cables in such a way
that there is no risk of tripping.
Caution!
Damage to the appliance
Frozen hoses may rip/burst.
Do not install the washer dryer in areas
exposed to frost or outdoors.
Caution!
Water damage
The connection points for the water
supply hose and water drain hose are
under high water pressure. To prevent
Positioning and connecting
leaks and water damage, you must
follow the instructions in this section.
Notes
In addition to the safety information
■
listed here, the local water and
electricity supplier may have special
requirements.
If in doubt, have the appliance
■
connected by a specialist.
Installation surface
The washer dryer must be stable
Note:
so that it does not move around.
The installation surface must be firm
■
and level.
Soft floors/floor coverings are not
■
suitable.
Installing the appliance on
a base or on a wooden joist
ceiling
Caution!
Damage to the appliance
The washer dryer may wander during
the spin cycle and topple or fall off its
base.
Always secure the washer dryer feet
with holding brackets.
Holding brackets: order no.
WMZ 2200, WX 975600, CZ 110600,
Z 7080X0.
If installing on a wooden joist
Note:
ceiling:
If possible, install the washer dryer in
■
a corner.
Screw water-resistant wooden board
■
(min. 30 mm thick) to the floor.
en
13
Advertisement
Table of Contents
