Connecting Ethernet Cable; Connecting Power Cable; Figure 6-9 Connecting The Ethernet Cable - Raisecom Gazelle S1512i-4GF-8GE-PWR User Manual

Table of Contents

Raisecom

Gazelle S1512i-PWR (A) User Manual

Connect the LC/PC fiber as below:

Step 1 Insert the SFP optical module into the optical interface on the Gazelle S1512i-PWR.

Step 2 Remove the dustproof covers of the optical module and fiber, and keep it for later use.

Step 3 Align the connector with the optical interface to insert the fiber into the optical interface

gently.

Step 4 To remove the fiber, push the fiber connector inwards slightly, and pull out the fiber.

6.4.2 Connecting Ethernet cable

Connect the Ethernet cable as below:

Step 1 Make the Ethernet cable according to specifications.

Step 2 Align the Ethernet cable head with the Ethernet interface of the Gazelle S1512i-PWR and

insert the Ethernet cable into the Ethernet interface gently, as shown in Figure 6-9.



The DC power interface on the Gazelle S1512i-PWR uses 5 PINs of the 8-pin Phoenix

connector with spaces of 5.08 mm. Connect the power cable as below:

Step 1 Make the DC power cable according to technical specifications.

Step 2 Insert the DC power cable plug into the power interface on the Gazelle S1512i-PWR properly,

as shown in Figure 6-10.

Ensure that the ground cable is grounded correctly before connecting the power

cable.

Disconnect all power supplies before connecting or removing the power cable.

Use the power cable which meets the technical specifications.

Raisecom Proprietary and Confidential

6 Hardware installation

Table of Contents