Appliance Setup; Remove Shipping Materials; Accessories; Front Door Removal / Installation - Quadra-Fire HUDBAY-FS Installation Manual

8 8
Appliance Set-Up
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
B. Accessories
Install approved accessories per instructions included with

accessories.

C. Front Door Assembly / Installation
HEAT SHIELDS HEAT SHIELDS
Before removing the door, notice the location
Figure 8.1 -
of the interior heat shields between door grille fins. The
heat shields will need to remain in these locations when
reattaching the door.
Stationary latches
Spring latches
Open lower access panel. Pull out and unhook
Figure 8.2 -
the two spring latches on the bottom of the appliance that
secure the door.
29
Quadra-Fire • Hudson Bay Installation Manual_R26 • 01/20
3
Step 1 - Pull the bottom of the door forward
Figure 8.3 -
approximately 1-1/2" (38mm). Step 2 - Grabbing the door
from the sides towards the top of the glass, push in on the
top of the door. Step 3 - Lift up off of the stationary latches
and away from the stove, removing the door.
NOTCHES ON LOWER NOTCHES ON LOWER
HEAT SHIELD HEAT SHIELD
When reassembling the door, be sure to line up
Figure 8.4 -
the lower shield in the middle grille, line up the grille post
with the notches in the lower heat shield. Once shields are
lined up (post should be flush with front of shields) push up
on the shields using the door and push in to allow the door
to rest on the latches. Figure 8.4.
Hook Notch
Notice Hook Notch on upper corner of front
Figure 8.5 -
assembly. Figure 8.5.
2
1
GRILLE POSTS GRILLE POSTS
3-90-7003999