Door Crown Installation; Grille Installation - Quadra-Fire HUDBAY-FS Installation Manual

The notch on the front assembly is hooked on
Figure 8.6 -
the retainer at the top of the stove. It will be necessary to
apply a small amount of force to the top of the front when
removing the front from the appliance. When pivoting the
front away from the appliance push up and inward to release
the hook notches from the notch retainers.
When reassembling the front to the appliance, be sure
notches are hooked into the retainers before attempting to
attach spring latches at the bottom of the front.
D. Door Crown Installation
Uninstall the existing crown by removing the four
Figure 8.7 -
screws on the back side of the door. Retain the screws.
Use a flat-head screwdriver to pry the black
Figure 8.8 -
crown free on the right side. Remove the crown and discard.
30
Notch Retainer Notch Retainer
Quadra-Fire • Hudson Bay Installation Manual_R26 • 01/20
Carefully align the left side of the crown into
Figure 8.9 -
place, and wrap it across the face of door, finally snapping
it into place on the right hand side. Reinsert and tighten the
screws previously removed.
Use a soft cloth and a window cleaning solution to clean
all fingerprint oils from the gold or nickel surface of crown
PRIOR to lighting the appliance.
E. Grille Installation
Following instructions stated above, remove
Figure 8.10 -
the door of appliance.
Remove the four screws (two at each end) holding the grille
in place. Lift up to remove.
Install the new grille by reversing the removal instructions.
NOTE: Clean glass and gold or nickel plating with glass
cleaner and a soft cloth, wiping off all fingerprints prior to
first fire to prevent permanent staining.
3-90-7003999