Electrical Information; Recommendation For Wire; Connecting To The Appliance; Standing Pilot Ignition System Wiring - Quadra-Fire HUDBAY-FS Installation Manual

7 7

Electrical Information

A. Recommendation for Wire
See B5 below for recommended maximum lead length (two
wire) when using wall thermostat/switch.
NOTE: This appliance must be electrically wired and
grounded in accordance with local codes or, in the
absence of local codes, with National Electric Code
ANSI/NFPA 70-latest edition or the Canadian Electric
Code, CSA C221.1.
• A 110-120 VAC circuit for this product must be protected
with ground-fault circuit-interrupter protection, in
compliance with the applicable electrical codes, when it is
installed in locations such as in bathrooms or near sinks.
B. Connecting to the Appliance
!
Wire 110v to electrical junction box.
Do NOT wire 110v to the valve.
Do NOT wire 110V to wall switch.
• Incorrect wiring will damage millivolt
systems.
1. This appliance may be used with a wall switch, wall
mounted thermostat and / or a remote control.
2. If using thermostat, use one compatible with a millivolt
gas valve system.
3. Follow parameters for locating thermostat (see individual
thermostat instructions) to ensure proper operation of
appliance.
4. Use low resistance thermostat wire for wiring from
ignition system to the wall switch and thermostat.
5. Use the following chart for wire sizing.
Wire Size
16 gauge
18 gauge
20 gauge
22 gauge
6. Keep wire lengths as short as possible by removing any
excess wire length.
7. Low voltage and 110 VAC voltage cannot be shared
within the same wall box.
27
WARNING
Max. Length
65 feet
40 feet
25 feet
18 feet
Quadra-Fire • Hudson Bay Installation Manual_R26 • 01/20
8. Ensure the thermostat is mounted level for accurate
readings.
9. The thermostat should be mounted on an inside wall
and not in direct line with the appliance convection air.
10. If the thermostat is located too close to the appliance,
you may need to set the temperature setting slightly
higher to maintain the desired temperature in your
home.
Do not connect this appliance to a thermostat serving
any other appliance.
Bedroom installation in Canada requires this appliance
to be connected to a thermostat.
!
Shock hazard
• This appliance is equipped with a three This appliance is equipped with a three
pronged (grounding) plug for your protection pronged (grounding) plug for your protection
against shock hazard and should be plugged against shock hazard and should be plugged
directly into a properly grounded three directly into a prop
prong receptacle. Do not cut or remove the
grounding prong from this plug.
C. Standing Pilot Ignition System Wiring
This appliance DOES NOT require 110 VAC supply for
operation. A wiring diagram is shown in Figure 7.1.
This appliance is equipped with a millivolt control valve.
WARNING
3-90-7003999