Table of Contents
Advertisement
Allow the cutting blades to reach full speed
before entering the material to be cut.
Always work going away from people and
solid objects such as walls, large stones, trees,
vehicles etc.
If the blade stalls, immediately stop the Hedge
trimmer. Disconnect the Hedge trimmer from
the mains and clear the jammed debris from
the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Move the Hedge trimmer to feed the branches
directly into the blade cutting edges.
Do not try to cut stems that are too large to feed
into the cutting blade.
TOP CUTTING
Use a wide sweeping motion (See I). A slight
downward tilt of the cutting blades in the
direction of motion gives the best cutting
results.
SIDE CUTTING
When trimming the sides of the hedge, begin
at the bottom and cut upwards (See J), tapering
the hedge inward at the top. This shape will
expose more of the hedge, resulting in a more
uniformed growth.
WARNING: Check extension cords
before each use. If damaged replace
immediately. Never use your tool with a
damaged cord since touching the damaged
area could cause electrical shock resulting
in serious injury.
If the supply cord is damaged, it should
be replaced by a local approved Service
Centre.
Take care not to expose this tool to rain.
MAINTENANCE
CLEANING
Disconnect from mains electrics supply. Using
a soft brush-remove debris from all air intakes
and cutting blade.
Wipe over surface of your Hedge trimmer with
a dry cloth.
WARNING:
Never use water for cleaning your Hedge
Hedge Trimmer
CT-WX4046HT WG200E WG201E-M-061219.indd 11
trimmer. Do not clean with chemicals, including
petrol, or solvents as this can damage your
hedge trimmer.
LUBRICATING THE CUTTING BLADE
For easier operation and longer life, lubricate the
cutting blades before and after each use. Before
lubricating, make sure your Hedge trimmer is
disconnected from the mains electricity supply.
Apply the oil so that it runs between the two
blades (See K).
Your trimmer should be stopped, disconnected
and oiled occasionally during use.
AT THE END OF THE CUTTING SEASON
Clean your Hedge trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the Hedge trimmer for any
worn or damaged parts.
TO STORE YOUR HEDGE TRIMMER
The Hedge trimmer blade cover/storage holder
is provided with 2 hanging slots for storing
the Hedge trimmer on the wall (See L) Ensure
the blade cover/storage holder is fitted before
storage. Store in a dry place where your Hedge
trimmer can be protected from damage.
ENVIRONMENT PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
PLUG REPLACEMENT (UK &
IRELAND ONLY)
If you need to replace the fitted plug then
follow the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
Blue – Neutral
Brown – Live
As the colors of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals
11
11
EN
2007-3-28 17:16:29
Advertisement
Table of Contents
