Starting And Stopping; Operating The Hedge Trimmer - Worx WX4046HT Manual

WARNING! DO NOT USE
THE PRODUCT
FITTING THE GUARD AND
FRONT HANDLE.
ASSEMBLY
ASSEMBLY OF THE GUARD
Insert the guard into the slot as illustrated in
A, allow the two locking tabs to insert into the
holes, ensure it is securely located. Then use
two screws to fix the guard securely.
THE FRONT HANDLE
ASSEMBLED BEFORE USE:
1) First, insert the left grooves-side to the
housing. (see Fig B)
2) Pull to insert the other side of the front handle
to the other side of the housing. (see Fig B)
3) Rotate each lock nut (7) as shown in Fig C.
Check and ensure the lock nuts are locked onto
the main housing.

STARTING AND STOPPING

BEFORE STARTING
10 10
TRIMMER
Remove blade cover (10) as illustrated in D.
TO START YOUR HEDGE TRIMMER
Connect to the mains and and switch on.
There are two switch levers fitted in your Hedge
trimmer (2&4).
Both switch levers need to be depressed for
the product to start. Depress and hold the front
switch lever (4) and press the switch lever (2)
(See E).
TO STOP YOUR HEDGE TRIMMER
Move Hedge trimmer away from cutting area
before stopping.
To stop, release one of the switch levers (See
G).
WARNING: If any parts are missing,
damaged or broken, do not operate
your Hedge trimmer until all damaged
parts have been replaced or repaired.
Failure to do so could result in serious
personal injury.
Hedge Trimmer
CT-WX4046HT WG200E WG201E-M-061219.indd 10
OPERATING
WITHOUT TRIMMER
REAR HANDLE EXTENSION
The rear handle of the Hedge trimmer can be
extended to increase the reach of your hedge
trimmer. To operate this feature you need to
press and hold the extension button (5) with
your thumb and pull the rear handle (1) away
from the main housing. You can choose from 4
preset positions for the rear handle (See H).
ADJUSTING
POSITION
Press and hold the two buttons (6) and rotate
(3), MUST BE
the front handle to the most comfortable angle.
The front handle will be locked after you release
the buttons. You can choose from 4 preset
positions for the front handle (See F). Caution:
ensure you support the weight of the hedge
trimmer before you adjust the front handle.
HOW TO USE YOUR HEDGE TRIMMER
For normal horizontal or vertical (side) cutting it
is recommended to not extend the rear handle
and to use the front handle in the two most
forward positions.
YOUR HEDGE
When you require a longer reach you must
extend the rear handle and use the front handle
in the two most rear positions.This will increase
your reach and maintain a balanced control
(See H).
The front handle has a switch lever which can
be activated on three sides. If your hand grip is
on the top or either side of the front handle you
can activate the switch whilst maintaining the
most comfortable hand grip position.
Inspect the area to be cut before each use,
remove objects which can be thrown or become
entangled in the cutting blades.
Always hold the Hedge trimmer with both
hands and with the blade away from you before
turning it on.
Always keep the power cord behind the
Hedge trimmer when in use. Do not place
it over the hedge that you are trimming
where it may be cut by the blade.
When trimming new growth, use a wide
sweeping action so that the stems are fed
directly into the blade.
THE HEDGE
THE FRONT HANDLE
EN
2007-3-28 17:16:28