Urinal water pipe section for urinals with concealed flushing system, urinal flush plates for prevista (manual and touchless flush actuation) (13 pages)
Table of contents Table of contents About these instructions for use 1.1 Target groups 1.2 Labelling of notes 1.3 About this translated version Product information 2.1 Standards and regulations 2.2 Intended use 2.2.1 Areas of use 2.3 Product description 2.3.1 Overview 2.3.2 Compatible components...
This restriction does not extend to possible operating instructions. The installation of Viega products must take place in accordance with the general rules of engineering and the Viega instructions for use.
About these instructions for use About this translated version This instruction for use contains important information about the choice of product or system, assembly and commissioning as well as intended use and, if required, maintenance measures. The information about the products, their properties and application technology are based on the current standards in Europe (e.g.
Product information Product information Standards and regulations The following standards and regulations apply to Germany / Europe and are provided as a support feature. Regulations from section: Fields of application / Mounting conditions Scope / Notice Regulations applicable in Ger‐ many Suitable masonry walls EN 1996-1-1...
Handling Handling Assembly information 3.1.1 Mounting conditions Suitable walls masonry walls concreted walls Metal support profiles The wall constructions must comply with the regulations in section Ä „Regulations from section: Fields of application / Mounting condi‐ tions“ on page 5. The bidet block may only be mounted on even wall surfaces.
Handling Assembly 3.2.1 Mounting the bidet block ▶ Break the locking clips off the wall mountings. ▶ Select the wall mountings so that they match the distance from the wall. ▶ Push the wall mountings into the element. ▶ Insert the locking clips. Prevista Pure bidet block...
Page 10
Handling ▶ Screw the metal angles to the bidet block. ▶ Adjust the construction height of the bidet block in accordance with the on-site marking of the upper edge of the finished floor. ▶ Mark the fixing points. X: 330 mm ▶...
Page 11
Handling ▶ Set the bidet block in the desired depth. You have attached the bidet block to the wall. ▷ Mounting in a niche ▶ Fold the tab forward. ▶ Insert the bidet block in the niche. ▶ Align the bidet block and screw it down. Prevista Pure bidet block...
Handling 3.2.2 Mounting the drain elbow ▶ Insert the mounting bracket for the drain elbow. ▶ Set the height of the drain elbow mounting bracket. ▶ Insert the drain elbow. ▶ Fasten the drain elbow using the bow. ▶ Put the protective plug of the drain elbow on. Prevista Pure bidet block...
Handling 3.2.3 Setting up and cladding the bidet block ▶ Mount the mounting bracket for the wall plates. ▶ Select the variant matching the respective sanitary item manufac‐ turer. ▶ Adjust the height and width of the mounting bracket. Prevista Pure bidet block...
Page 14
Handling ▶ Insert the threaded rods at the desired position. X1: 180 mm X2: 230 mm ▶ Turn in the threaded rods by hand. ▶ Tighten the nuts of the threaded rods with a fork spanner. ▶ Place the protective caps on the threaded rods. ▶...
Handling Disposal Separate the product and packaging materials (e. g. paper, metal, plastic or non-ferrous metals) and dispose of in accordance with valid national legal requirements. Prevista Pure bidet block...
Page 16
Viega Technology GmbH & Co. KG service-technik@viega.de viega.com INT • 2020-02 • VPN180025...