Viega PureFlow Press Zero Lead Product Instructions

Product Instructions
Viega PureFlow Press
®
by ProPress Adapter
®
1 2
7 8
13 14
EN
Viega PureFlow Press Zero Lead by
ProPress Adapter
Making a PureFlow Press with Hand Tool
Viega products are designed to be
installed by licensed and trained plumbing
and mechanical professionals who are
familiar with Viega products and their installation.
Installation by non-professionals may void
Viega LLC's warranty.
Zero lead identifies Viega products meeting
the lead free requirements of NSF 61-G
through testing under NSF/ANSI 372 (0.25%
or less maximum weighted average lead content).
1
Square off tubing to proper length. Uneven,
jagged or irregular cuts will produce unsatisfactory
connections.
2
Insert PureFlow Press fitting with attached sleeve
into tubing and engage fully.
Viega LLC
585 Interlocken Blvd.
Broomfield, CO 80021
Phone (800) 976-9819
www.viega.us
3 4
10
9
15 6 16
3
Ensure full tubing insertion at view holes in
attached press sleeve. Full insertion means tubing
must be completely visible in at least two view
holes and partially visible in the one.
4
Position press tool perpendicular over Press
Sleeve and close tool jaws to engage ratchet.
It may be necessary to rotate the locator
ring to avoid interference between the ring
and tool.
5
Close handles, using trigger to reduce grip span if
desired.
6
Extend handle and continue ratcheting until automatic
tool release occurs at proper compression force.
CAUTION!
Do not press twice.
7
Turn screw for emergency release.
WARNING!
The connection is not leakproof when the
tool has been opened by emergency release.
Product Instructions
EN
Viega PureFlow Press by
ProPress Adapter
This document is subject to updates. For the most current Viega
technical literature please visit www.viega.us.
Instrucciones del producto
ES
Viega PureFlow Press por
Adaptador ProPress
Este documento está sujeto a actualizaciones. Para obtener la
documentación técnica más reciente de Viega, visite www.viega.us/es.
Instructions produit
FR
Viega PureFlow Press
avec adaptateur ProPress
Le présent document est soumis à des mises à jour. Pour consulter
les manuels techniques Viega les plus récents, veuillez visiter
www.viega.ca.
PI-PF 560957 0621 PureFlow Press x ProPress (EN ES FR)
6 5 6
6 11 12
Making a ProPress Connection
For Types K, L and M Hard Copper Tubing in ½" to 2"
and Soft Copper Tubing in 5" to 1¼"
WARNING!
Read and understand all instructions for
installing ProPress fittings. Failure to follow
all instructions may result in extensive property
damage, serious injury or death.
8
Cut copper tubing at right angles using
displacement type cutter or fine-toothed steel saw.
9
Remove burr from inside and outside of tubing to
prevent cutting sealing element.
10
Check seal for correct fit. Do not use oils or
lubricants. Use only ProPress Shiny Black EPDM
or Dull Black FKM Sealing Elements.
11 Mark proper insertion depth as indicated by the
ProPress Insertion Depth Chart. Improper insertion
depth may result in improper seal.
Copper tubing must be free of surface
imperfections, including metal stamped print
lines, before a ProPress fitting is installed