Honda 08V31-T7A-100 Installation Instructions Manual page 13

32. Using isopropyl alcohol on a shop towel, thoroughly
clean the front bumper beam where the aluminum
tape will attach.
FRONT
BUMPER
BEAM
ALUMINUM
TAPE
33. Secure the fog light harness to the front bumper
beam with two pieces of aluminum tape as shown.
34. With the help of an assistant, bring the front bumper
close to the vehicle, and plug the two fog light
harness 2-pin connectors into the right and left fog
light. Install the front bumper.
RIGHT 
FOG LIGHT
FRONT BUMPER
© 2019 American Honda Motor Co., Inc. – All Rights Reserved.
FRONT
BUMPER
BEAM
Clean with
isopropyl
alcohol.
FOG LIGHT
QD42015AH
HARNESS
2 FOG LIGHT HARNESS
2-PIN CONNECTORS
LEFT 
FOG LIGHT
Routing the Switch Harness
35. Install the relay to the switch harness relay block.
36. Plug the switch harness 1-pin connector into the
vehicle 1-pin connector.
SWITCH HARNESS
1-PIN CONNECTOR
DRIVER'S DASHBOARD
LOWER COVER OPENING
STEERING SHAFT
AII12705-21 (1911)
RELAY
SWITCH HARNESS
RELAY BLOCK
VEHICLE 1-PIN
CONNECTOR
QD42017BH
13 of 19