Advertisement
THIS EQUIPMENT TO BE INSTALLED WITH ADEQUATE BACKFLOW PROTECTION.
RECOMMENDED PART ...APOLLO MODEL NO. DUCLF4A
Water Regulation is highly recommended. Set water regulator to 65 PSIG.
Water pipe connections and fixtures
directly connected to a potable water
supply shall be sized, installed and
maintained in accordance with federal,
state and local codes.
D. CONNECTING SUPPLY LINES TO
SOURCES
1. Use beverage barb fittings (1/4")
to attach inlet water and syrup
concentrate to flex tubing located
at end of shut-off blocks. Water
and syrup concentrate lines are
identified in Fig 3.2. Tubing can
be routed through a hole in the
countertop. Ensure proper size hose clamps are used to secure tubes.
2. Turn water and syrup concentrate on at the source.
3. Turn water and syrup concentrate on at the shut-off blocks by rotating gray shut-off knobs
clockwise (See Fig. 3.3). Verify the water is set to the target pressure of 65 PSIG and the
syrup is set to the target pressure.
TO REMOVE FRONT MERCHANDISER
TURN CAM LOCK
COUNTER CLOCKWISE
TWIST KNOB COUNTER
CLOCKWISE TO UNLOCK
AND OPEN LED DOOR
IMPORTANT
NOTE:
Fig. 3.2
View from back of unit
with back panel removed
INDIVIDUALLY LABELED
PUSH DOWN AND THEN
OUT ON TOP OF
MERCHANDISER
LIFT MERCHANDISER FROM
BOTTOM SLOTS
Fig. 3.3
Off
On
PLASTIC TIES
CAN BE CUT
AS NEEDED
5
Advertisement
