Advertisement
IMPORTANT
THIS APPLIANCE IS NOT TO BE USED BY
CHILDREN OR PERSONS WITH REDUCED
PHYSICAL, SENSORY OR MENTAL
CAPABILITIES, OR LACK OF EXPERIENCE
AND KNOWLEDGE, UNLESS THEY
HAVE BEEN GIVEN SUPERVISION OR
INSTRUCTION.
CHILDREN SHOULD BE SUPERVISED
TO ENSURE THEY DO NOT PLAY WITH
APPLIANCE.
B. (OPTIONAL) ATTACHING DISPENSER TO COUNTERTOP
The 4 Flavor Electric Dispenser can be installed loose on the countertop or mounted to the
countertop.
1. If the dispenser will be installed loose, bumper foot pads are factory installed (P.N. 333-0006)
and should be used to alleviate sliding of dispenser. (Fig. 3.1)
2. If the dispenser will be mounted to the countertop, remove bumper foot pads by pulling firmly
on each pad and dispose of properly. Use fastener kit (P.N. 670-0058) containing the following
parts:
•
(4 each) Bolt, 10-24
•
(4 each) Spacer
•
(8 each) Nut, Hex, 10-24
•
(4 each) Washer, Flat
a. Attach the bolts to the inner support bracket using
a washer and nut. Tighten the nut to keep the bolt
firmly attached to the inner bracket.
b. Using the template, locate the desired position of the dispenser and mark the center of the
holes on the counter. Drill holes using 13/64 drill bit.
c. Set dispenser on counter so that bolts protrude through holes in the countertop.
To comply with National Sanitation Foundation (NSF) requirements with the United States,
unit base must be sealed to the countertop if no cleaning under unit will occur.
d. Liberally apply Silastic
bottom edge.
e. Apply additional sealant around bottom of base. Seal must have a minimum 1/2" radius to
prevent crevices and to ensure a complete seal.
f. Allow sealant to dry to MFG recommendations.
g. Assemble washers and nuts to bolts from underneath the countertop. Tighten firmly.
DO NOT OVER TIGHTEN!
Fig. 3.1 (Bottom of unit)
OBVIOUS SIGN
OF DAMAGE
NOTE:
sealant (such as Dow Corning RTV 730 or equivalent) on base
®
PUSH FOOT INTO OPENING
(NO TOOLS REQUIRED)
BOLT
SPACER
WASHER
NUT
PN 333-0006
INNER BRACKET
3
Advertisement
