Step 6: Connect Power Cord; Step 7: Install The Filters - Waterdrop WD-G3-B Instruction Manual

3. Install the "WASTE" Water Tubing
• Remove the plug from "WASTE" water port;
• Identify the red 1/4" PE tubing which has been attached to the drain saddle (Figure 15);
• Insert the other end of the tubing into the "WASTE" water port (Figure 16), and pop the lock
clip on the fitting.
NOTE: Make sure it is fully inserted until you reach the mark on the tubing.
Figure 15
Connect RO faucet with the system: Insert the power cord which is attached to the RO faucet
into the "FAUCET" connector (Figure 17) at the back of the housing, and tighten the nut.
Connect Power Adapter: Insert the DC head of power adapter into the "POWER" port at the
back of the housing (Figure 18).
NOTE: Please do not connect power socket now.
Each filter is marked with a logo (CB/CF/RO) and an installation arrow.
1. Remove wrappings and protective cap from the filter;
2. Insert the filter into its corresponding hole (Figure 19), align the arrow with the empty
circle on the housing (Figure 20);
3. Twist the filter with a little force forward in clockwise direction for 90 degrees, until the
arrow is aligned with the solid circle on the housing (Figure 21). You may hear a clicking
sound when the filter is fitted into the place properly;
4. Repeat the above steps to install the other two filters.
Drain
Saddle
"WASTE" Water
Tubing
Step 6:
Connect Power Cord
"FAUCET" Connector
Figure 17
Step 7:
Install the Filters
"WASTE"
Water Tubing
Lock Clip
Figure 16
"POWER" Port
Figure 18
9
"WASTE"
Water Port