Table of Contents
Advertisement
DPB-600
2-3 Resassembling trigger switch grip
H
Fig. P
6 pole terminals
4 pole terminal
D
E
HANDLE GRIP
A
N
D
E
t
1. Install throttle lever (N) on handle lid (A) and
fasten with the torx bolt (H). Check throttle lever (N)
works smoothly and set to the position as shown
(Fig. P : STOP position).
2. The terminal has no locking Tabs on connectors.
Gently push until connector is fully seated on con-
trol board assy (D) and switch (E).
3. Install switch (E), wire harness (t) and control
board (D) on fan case as shown.
7
Advertisement
Table of Contents
