DPB-600
3-3 Reassembling motor case
G
H
G
H
h g
(B)
(A)
MOTOR CASE
C
D
E
F
b
L
K
1. Assemble control board assy to the fan case as
shown and connect couplers of the lead terminal
(C), (D) of the handle lid side each other.
2. Connect assembly motor side coupler (E), (F).
Note: Assemble so that motor's lead wire goes
through the upper part, and lead terminal's lead
wire goes through the bottom as shown. Install
each lead wires without sticking out to the outside
of a case lib (b).
3. Connect couplers of a thick lead wire (G) and (H).
4 . A s s e m b l e t h i c k l e a d w i r e ( K ) , ( L ) a n d a
couplers(G), (H) to a motor case as shown.
Note: Assemble the lead wire to the groove of the
motor case surely. Install the connection coupler
so that claw part turns outward (g), (h).
5. Fasten motor cover (B) by torx bolts (A).
11