Table of Contents
Advertisement
8
DPB-600
HANDLE GRIP
2-3 Resassembling trigger switch grip (continued)
D
t
4. When installing lead (v) and wire harness (t),
make sure they are installed into the groove part.
v
5. When installing control board assy (D), attach
control board so that its claw part comes to the left
C
c
side as the left fi gure.
6. Fix throttle trigger (C) on handle. When fixing
it, hook the claw part of the throttle trigger (c) with
handle as shown.
7. Install throttle trigger (C) so as not to be
contacted with wire harness (t). Fit harness (t) into
the groove fi rmly.
B
8. Insert the rear end of handle lid (A) into the
A
motor cover, and fasten torx bolt (V).
9. Align the claw of handle grip with the groove of
handle lid (A), and fasten by torx bolt (B).
V
Advertisement
Table of Contents
