Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Echo PB-200 - 03-03
Summary of Contents for Echo PB-200 - 03-03
- Page 1 Power Blower Operator's Manual MODEL PB-200 Serial Number 05001001 - 05999999 WARNING DANGER Read rules for safe operation and all instructions carefully. ECHO provides this Operator’s Manual, which must be read and understood for proper and safe operation. X753000710 X7531130100 03/03...
-
Page 2: Table Of Contents
NTRODUCTION Welcome to the ECHO family. This ECHO product was designed and manufactured to provide long life and on-the-job- dependability. Read and understand this manual. You will find it easy to use and full of helpful operating tips and SAFETY messages. -
Page 3: Manual Safety Symbols And Important Information
Locate these safety decals on your unit. Make sure the decals are legible and that you understand and follow the instructions on them. If a decal cannot be read, a new one can be ordered from your ECHO dealer. See PARTS ORDERING instructions for specific information. -
Page 4: International Symbols
Proper clothing and safety gear must be worn when operating a blower. Hearing Protection Physical Condition ECHO recommends wearing hearing protection whenever Your judgment and physical dexterity may not be good: unit is used. -
Page 5: Extended Operation/Extreme Conditions
NOT operate unit if leaks are found. • Do not use blower if any part is missing or damaged. • Have repairs done only by an authorized ECHO Service dealer. • Do not use any attachment, accessory or replacement part unless it is recommended in this Operator's Manual. -
Page 6: Safe Operation
SAFE OPERATION Noise Control • Follow local noise regulations on sound levels and hours of operations. Use only WARNING DANGER during appropriate hours. Do not operate this product indoors or in inadequately ventilated • Never use a higher speed setting then areas. -
Page 7: Description
1 - Blower Pipe Assembly 1 - Operator's Manual 1 - Warranty Registration Card 1 - ECHO Emissions and Warranty Statement 1 - Echo Power Blend 2-stroke oil sample 1. STOP SWITCH - "SLIDE SWITCH" mounted on top of handle. Push forward to start and run. Slide back to stop. -
Page 8: Specifications
PECIFICATIONS MODEL ----------------------------------------------------- PB-200 Hand Held Length ------------------------------------------------------- 330 mm (13.0 in.) (w/o pipes) Width -------------------------------------------------------- 215 mm (8.5 in.) Height ------------------------------------------------------- 340 mm (13.4 in.) Weight (dry) ------------------------------------------------ 3.8 kg (8.38 lb.) Engine Type ------------------------------------------------ Air cooled, two-stroke, single cylinder gasoline engine Displacement ----------------------------------------------- 21.2 cc (1.39 cu. -
Page 9: Pre-Operation
Echo premium Power Blend Universal 2-Stroke Oil may be mixed an approved fuel storage container. at 50:1 ratio for application in all Echo engines sold in the past regardless of ratio specified in those manuals. Storage - Fuel storage laws vary by locality. Contact... -
Page 10: Operation
PERATION • Provide all operators of this equipment with the Operator's Manual and instructions for safe operation. • Before starting the unit, equip yourself and any other person working within the 15 m (50 ft.) Safety Zone with the required Protective Equipment and clothing. -
Page 11: Starting Warm Engine
Move stop switch (B) to "Stop" position. WARNING DANGER If engine does not stop when stop switch is moved to STOP position, close choke - COLD START position - to stall engine. Have your ECHO dealer repair stop switch before using blower again. -
Page 12: Operating Blower
OPERATING BLOWER WARNING DANGER Always wear safety glasses, hearing protection and a face filter mask or serious personal injury may result. . Do not point the blower pipe in the direction of people or pets. Read the Safety Section carefully. IMPORTANT To avoid engine damage due to over-revving, do not block blower pipe. -
Page 13: Maintenance
ECHO Service Dealer for maintenance. To help you decide whether you want to DO-IT-YOURSELF or have the ECHO Dealer do it, each maintenance task has been graded. If task is not listed, see your ECHO Dealer for repairs. -
Page 14: Air Filter
AIR FILTER Level 1. Tools required: 25-50 mm (1-2 in.) Cleaning brush. Parts required: 90008 REPOWER Air and Filter Kit NOTE Clean daily. 1. Close choke (Cold Start Position). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from the air cleaner area. -
Page 15: Spark Plug
OWER LOWER PERATOR ANUAL SPARK PLUG Level 2. Tools required: 3/4 in. Spark Plug deep socket, Feeler gauge Parts Required: REPOWER Tune-Up Kit P/N 90074 1. Remove spark plug and check for fouling, worn and rounded center electrode. 2. Clean the plug or replace with a new one. DO NOT sand blast to clean. -
Page 16: Exhaust System
Cleaning Cylinder Fins 1. Remove spark lead and spark plug. 2. Remove two upper 3 mm hex screws at recoil starter. 3. Remove engine cover (five screws), pull cover away from engine. Loosely install spark plug to prevent dirt from entering cylinder. Clean cylinder fins to allow cooling air to pass freely. -
Page 17: Carburetor Adjustment
The cylinder exhaust port must be inspected and cleaned of excess carbon every 3 months or 90 hours of operation in order to maintain this engine within the emissions durability period. ECHO strongly recommends that you return your unit to your ECHO dealer for this important maintenance service. CARBURETOR ADJUSTMENT... -
Page 18: Troubleshooting
ROUBLESHOOTING r o t r o t i a r i l l r o t r e l i l y i l y r o t r e l f f u r e l h t i r u t r / n r i a... -
Page 19: Storage
8. Install the spark plug (do not connect ignition carburetor. cable). 7. Remove the spark plug and pour 7cc (1/4 oz.) of 9. Remove blower pipe assembly from unit. fresh, clean ECHO 2-stroke engine oil into the cylinder through the spark plug hole. -
Page 20: Servicing Information
• Sending a check or money order for $2.00 per Parts Catalog or $1.50 per Operator's Manual made payable to ECHO, INCORPORATED. State on a sheet of paper the model number and serial number of the ECHO unit you have, part number of the manual (if known), your name and address and mail to address below.