Baldor VS1STS Series Installation & Operating Manual page 20

Note 1
Note 2 * Optional
Reactor
Note 1
See Recommended Tightening
Torques in Table 4-1.
4-4 Power Wiring
Figure 4-3 Motor Connections and Optional Connections
Baldor
Control
U V W GND
M
A1 B1 C1
Load
A2 B2 C2
V W
U G
* AC Motor
* Optional components not provided with control.
* Optional M Contactor Connections
To Power Source
(Rated Coil Voltage)
* M Enable
M=Contacts of optional M-Contactor
Note 3
Notes: 1. Metal conduit should be used. Connect conduits
so the use of Load Reactor or RC Device does not
interrupt EMI/RFI shielding.
2. See Line/Load Reactors described previously in
this section.
3. Use same gauge wire for ground as for U, V and W.
* Optional
* M-Contactor
RC Device
M
Electrocube
RG1781-3
MN767S