Vaderstad Carrier X Series Instructions Manual page 18

Instructions and settings
2.3.2 Unhitching and parking the implement in working mode
B
Figure 2.4
1 Lower the implement, set to working mode, on to the base so that it stands on its discs and roll-
er.
2 Set the working depth of the front tool so that the implement is standing parallel. Surface (A)
must be parallel to the base.
3 Fit as many spacers as you can to the front tool setting hydraulic ram (B). Also see "2.11 Set-
ting disc working depth" on page 28.
4 Disconnect the hydraulic hoses and three point couplings.
18
A
01.05.2015 1