Rear Panel Features; Top Panel Features - Numark NS7 Reference Manual

V7

REAR PANEL FEATURES

1. POWER IN – Use the included power cable to connect
V7 to a power outlet. While the power is switched off,
plug the cable into V7 first, then plug the cable into a
power outlet.
2. POWER SWITCH – Turns V7 on and off. Turn on V7
after all input devices have been connected and before
you turn on amplifiers. Turn off amplifiers before you
turn off V7.
3. USB – This USB connection sends and receives audio
and control information from a connected computer.
Refer to the USB OPERATION section for more information.
4. DECK A / DECK B OUTPUT (RCA) – Use standard RCA cables to connect these outputs for Deck A and Deck B to the left and
right channels (respectively) of your mixer.
5. MOTOR TORQUE – Flip this switch to adjust the torque of the PLATTERS. At the high setting, the PLATTERS will have the
heavier, stronger feel of "modern" turntables. At the lower setting, they are lighter and more graceful – the feel of a "classic"
turntable.
6. REMOTE – If you are using a "fader start"-compatible mixer, you can start and cue music automatically on the V7 by moving the
mixer's crossfader towards it. To use fader start, connect the V7's REMOTE output to your fader start-compatible mixer with
standard 1/8" cables.
7. LINK CONNECTION – If you are using two V7s, connect their LINK CONNECTIONS with the included link cable.
8. DECK LOCATION SWITCH – Reserved for future use.

TOP PANEL FEATURES

9
14
10 11 12 13
15 16 17 18
21
5
6
20
35
37
36
7 8
38 4
19
29
26
30
33
40
1
27
27
8 8 8 8
3 2
AC IN 100V-240V
50-60Hz 50W
POWER
2 1
USEFUL TERMS:
28
Audio Pointer: The current position in a track
29
from where audio will play. When you select a
track and begin playing, the Audio Pointer will
31 32
usually start from the beginning and stop at the
end.
34 33
Cue Point: A marked position in a track, which
will be permanently stored by the software. You
39 41
can set, return to, or delete Cue Points with the
CUE CONTROLS.
42
Temporary Cue Point: A marked position in a
track, which will only remain while that track is
22
still loaded in the Deck. You can set and return
to the Temporary Cue Point with the CUE button.
23
24
25
8
DECK B DECK A
L L
4
USB LINK DECK REMOTE MOTOR
LOCATION TORQUE
RIGHT LEFT HIGH LOW
R R
7 8 5
3
OUTPUT
6