Advertisement
Chapter 1 Install the Bay and Backplane Connections
Stop. You have completed this procedure.
NTP-F112 Install Cable Routing Modules and Kick Plates
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Note
To accommodate the CRMs, the bay must have 150 millimeters (6 inches) of open space on either side
(900-mm [35.4-inch] footprint).
Note
Two people are required to perform this procedure.
Step 1
If you want to install narrow CRMs, complete the
page
Step 2
If you need to remove narrow CRMs (vertical fiber routers) so you can install wide CRMs, complete the
"DLP-F257 Remove the Narrow CRMs" task on page
Step 3
If you want to install wide CRMS and have 600-mm (23.6-in.) kick plates installed, complete the
"DLP-F258 Replace the Existing 600-mm Kick Plates with 900-mm Kick Plates" task on page
If you want to install the wide CRMs, complete the
Step 4
page
November 2009
This procedure explains how to install narrow CRMs or, if necessary,
remove any previously installed narrow CRMs and install the wide CRMs.
Screwdriver
Retaining screws
900-mm kick plates (53-2178-01)
Wide cable routing module (CRM) kit (53-2181-XX) (optional):
•
•
•
•
•
Narrow CRM kit (53-2193-01) (optional):
•
•
•
•
As needed
Onsite
None
17-65.
17-65.
NTP- F112 Install Cable Routing Modules and Kick Plates
Latch catches (2 left and 2 right)
Velcro tie-wrap (26)
Wide CRMs (2 left and 2 right)
6-32 panhead screws (8; for latch catches)
8-32 panhead screws (10; for wide CRMs)
Fiber radiuses (2; left and right)
Narrow CRMs (2; left and right)
6-32 panhead screws (4; for fiber radiuses)
8-32 panhead screws (6; for narrow CRMs)
"DLP-F276 Install the Narrow CRMs" task on
17-49.
"DLP-F277 Install the Wide CRMs" task on
Cisco ONS 15600 SDH Procedure Guide, R8.0
17-51.
1-9
Advertisement
