Advertisement
NTP- F111 Open and Remove the Front Door
Figure 1-1
ONS 15600 SDH Front Door
ESD jack
Pull each latch outward to release them.
Step 2
Swing the door up to open it.
Step 3
Lift the door off its hinge pins and remove it. Set the door aside so you can reinstall it after you complete
Step 4
Chapter 2, "Install Cards and Fiber-Optic Cable."
If you want to install CRMs, continue with the
Step 5
Plates" procedure on page
Bay Power and Ground" procedure on page
Cisco ONS 15600 SDH Procedure Guide, R8.0
1-8
"NTP-F112 Install Cable Routing Modules and Kick
1-9. If CRMs are already installed, continue with the
1-10.
Chapter 1 Install the Bay and Backplane Connections
Door pivot point
Door latches
"NTP-F113 Install the
November 2009
Advertisement
