Advertisement
Chapter 1 Install the Bay and Backplane Connections
NTP-F116 Replace the Rear Cover
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Grasp the clear plastic cover on each side.
Step 1
Align the cover with the holes provided for the screws.
Step 2
Step 3
Screw the retaining screws that hold the clear plastic cover in place.
Stop. You have completed this procedure.
NTP-F117 Perform the Bay Installation Acceptance Test
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In
Table
Step 1
Table 1-1
Description
NTP-F108 Unpack and Inspect the ONS 15600 SDH Bay Assembly, page 1-4
NTP-F109 Install the Bay Assembly, page 1-5
NTP-F111 Open and Remove the Front Door, page 1-7
November 2009
This procedure replaces the rear cover.
Screwdriver
Retaining screws
As needed
Onsite
None
This procedure performs a bay installation acceptance test.
Voltmeter
NTP-F108 Unpack and Inspect the ONS 15600 SDH Bay Assembly, page
1-4
NTP-F109 Install the Bay Assembly, page 1-5
NTP-F111 Open and Remove the Front Door, page 1-7
NTP-F113 Install the Bay Power and Ground, page 1-10
NTP-F114 Remove the Rear Cover, page 1-11
NTP-F115 Install Wires to Alarm, Timing, LAN, and Craft Pin
Connections, page 1-12
Required
Onsite
None
1-1, verify that each procedure was completed.
ONS 15600 SDH Bay Installation Task Summary
NTP- F116 Replace the Rear Cover
Cisco ONS 15600 SDH Procedure Guide, R8.0
Completed
1-13
Advertisement
