Tennant ATLV 4300 Instruction Bulletin page 6

Hide thumbs Also See for ATLV 4300:

Enlarged version

FILTER HOUSING DUCT INSTALLATION:

1. Mount the vacuum exhaust plate gasket (15) to the

new vacuum exhaust plate (14), then attach the

vacuum exhaust plate (14) to the vacuum fan housing

with pan screws (16) and washers (17).

(Refer to FIG. 5 and 7)

2. Insert the new filter bag (9) through the top opening of

the filter housing (1). Place the filter bag's elastic band

over the lip of the filter housing (1).

(Refer to FIG. 5 and 7)

Note: The filter bag is now inserted inside the filter housing.

3. Mount one end of the filter inlet duct (1) over the

vacuum exhaust plate (14) with the worm drive

clamps (2). (Refer to FIG. 5 and 7)

Note: The filter bag is now kept in the filter housing, and no

longer mounts to the vacuum fan housing.

4. Place the bottom end of the filter inlet duct (1) over the

opening in the plastic filter housing. Check that the

inlet duct (1), and the retaining clamp (3) fit over the

lip of the plastic housing, and the filter bag (9). Secure

the filter inlet duct (1) in place with the draw latch on

the retaining clamp (3).

(Refer to FIG. 5 and 7)

5. Mount the label mounting bracket (25) to the plastic

filter housing (1) with screws (23), washers (26) and

lock nuts (24). Place warning decals 367667 and

367668 from the label kit onto the label mounting

bracket. Discard the rest of the label kit.

(Refer to FIG. 6)

6. If the machine is equipped with a slow--moving vehicle

sign, mount the SMV label bracket (34) to the filter

door (32) with hex screws, (13) and washers (4).

Attach the sign to the bracket (34). (Refer to FIG. 6)

7. Open the debris canister and replace the liners and

garbage bags. Close and latch the canister.

8. Start the machine and check the vacuum dust filter kit

for proper operation.

IB 340133 (10-02)