Oregon 730-120 Original Instruction Manual page 27

730-120
3. Place the chain, with the cutter to the left of
the depth gauge, into the groove on the
chain vise.
4. Pull the chain around by hand to make sure
that it runs freely in the chain vise.
CAUTION Always wear gloves and
protective eyewear while you work and
operate your grinder.
5. Loosen the locking handle and move the
tensioner upward or downward to make
enough room to position the chain.
6. Lift the tensioner arm (there is a quick
release function) and place the chain below
the tensioner roll.
7. Lower the tensioner arm to its bottom
position.
Operation
27