Arrow Everest-CortexM1-SFP+Loop-Demo User Manual page 15

Arrow Central Europe GmbH
User Guide
The design is already fully implemented and ready to be programmed on the Everest Board.
The board has to be connected with the power supply and to the PC with the USB cable. All
drivers have to be installed (which should happen automatically when plugged in the first time)
To program the design, there are two possibilities:
Programming via Libero PolarFire SoC: Programming is started with the "Run
-
PROGRAM Action" Button in the Design Flow Pane
- Programming
Directory>\designer\CortexM1_Subsystem\export\CortexM1_Subsystem.stp")
can be programmed with the FlashPro Software. A new FlashPro project has to be
generated and the programming file loaded into.
via FlashPro Software: There is a STAPL-File
page 15
Everest-CortexM1-Demo
("<Design
which