3Com CoreBuilder 3500 Getting Started Manual page 30

30 C 3: I
HAPTER NSTALLING
Remove the faceplate by grasping the injector/ejector
5
handles and simultaneously rolling them outward.
See Figure 9. Save the faceplate for future use.
Figure 9 Removing a Faceplate
PCMCI
R
ERROR
N
R S
PWR RUN SYS INS PS1 PS2 FAN
Captive screw
Remove the module from its antistatic bag.
6
Verify that the injector handles are in the outward
7
position.
Place the module between the guides of the selected
8
slot and slide the module gently into the chassis until
it stops. See Figure 10.
To seat the module, firmly roll the injector handles
9
inward to engage the backplane connectors. You feel
a slight resistance as the connectors engage.
CAUTION: If the resistance is too great, the
connectors may not be aligned. Forcing the module
inward can damage the connectors. If necessary,
remove and reinsert the module, ensuring that the
connectors are properly aligned. Do not seat the
module by tightening the captive screws.
M M
EDIA ODULES
ETHERNET
MODEM TERMINAL
10BT
INS
TEMP CONFIG
Faceplate
Figure 10 shows a module that is being installed in a
system.
Figure 10 Installing a Module
PCMCI
R
ERROR
R N S
PWR RUN SYS INS PS1 PS2 FAN TEMP CONFIG
Captive screw
Tighten the module's captive screws to firmly secure
10
the module in the chassis.
Repeat steps 1 through 10 to install the remaining
11
modules.
The module is now ready to be cabled. See
Chapter 4.
ETHERNET
MODEM TERMINAL
10BT
INS
100 BASE - TX
3C35210 1X 2X 3X 4X 5X 6X
L E T L E T L E T L E T L E T L E T
PWR
INS
ERR
Module