Verification After Power-On - H3C S9500E Series Connecting Manual

Starting application at 0x00100000 ...
TLB init OK.
LBC init OK.
LAW init OK.
Bsp init start...
MMU init OK.
CRC init OK.
Frame data init OK.
Connect IRQ 0 OK.
Enable IRQ 0 OK.
Connect IRQ 1 OK.
Enable IRQ 1 OK.
Connect IRQ 2 OK.
Enable IRQ 2 OK.
Connect IRQ 4 OK.
Enable IRQ 4 OK.
Connect IRQ 5 OK.
Enable IRQ 5 OK.
Connect IRQ 6 OK.
After the switch completes booting the applications, the following information appears on the terminal
screen:
Press ENTER to get started.
Press Enter to begin configuring the switch at the prompt:
<H3C>
NOTE:
The S9500E switches provide a command line interface (CLI). For more information about the CLI, see
•
H3C S9500E Switch Series Fundamentals Configuration Guide.
The output depends on your switch model.
•

Verification after power-on

H3C recommends that you check the following conditions after the switch is powered on:
The cooling system is working. You should be able to hear fan rotation noise and feel air being
•
blown out.
All the LEDs are functioning properly.
•
Table 2 LED status when the switch operates properly
Part
MPU
LED Name/Color
SFC (green)
MPU status LED ACT (green)
RUN (green)
LPU status LED RUN (green)
Status
Steady on
•
Active MPU—Steady on
•
Standby MPU—Off
Flashing
Flashing
7