Preparation; Overview: Preparation; Preparing The Installation Site; Installation Site Requirements Of The Indoor Unit - Daikin FTXP50M2V1B Installer's Reference Manual

5 Preparation

5.1 Overview: Preparation

5.2 Preparing the installation site

5.2.1 Installation site requirements of the indoor unit

FTXP50~71M2V1B + FTXF20~71A2V1B + ATXF50~71A2V1B
Daikin room air conditioner
4P513661-8H – 2019.12
This chapter describes what you have to do and know before going on-site.
It contains information about:
▪ Preparing the installation site
▪ Preparing the refrigerant piping
▪ Preparing the electrical wiring
Do NOT install the unit in places often used as work place. In case of construction
works (e.g. grinding works) where a lot of dust is created, the unit MUST be
covered.
Choose an installation location with sufficient space for carrying the unit in and out
of the site.
WARNING
The appliance shall be stored in a room without continuously operating ignition
sources (example: open flames, an operating gas appliance or an operating electric
heater).
INFORMATION
Also read the precautions and requirements in the "General safety precautions"
chapter.
INFORMATION
The sound pressure level is less than 70 dBA.
▪ Air flow. Make sure nothing blocks the air flow.
▪ Drainage. Make sure condensation water can be evacuated properly.
▪ Wall insulation. When conditions in the wall exceed 30°C and a relative humidity
of 80%, or when fresh air is inducted into the wall, then additional insulation is
required (minimum 10 mm thickness, polyethylene foam).
▪ Wall strength. Check whether the wall or the floor is strong enough to support
the weight of the unit. If there is a risk, reinforce the wall or the floor before
installing the unit.
Install power cables at least 1 metre away from televisions or radios to prevent
interference. Depending on the radio waves, a distance of 3 metres may NOT be
sufficient.
▪ Choose a location where the hot/cold air discharged from the unit or the
operation noise, will NOT disturb anyone.
5 Preparation
|
Installer reference guide
19