Assembly Procedure - Kayoba 003-151 Operating Instructions Manual

EN
31. Training computer x 1
32. Guard x 1
33. Mains adapter x 1
34. Self-tapping screw (ST4.2 x 18) x 10
35. Wave washer x 4
36. Carriage screw (M8 x 45) x 4
37. Hex screw (M8 x 45) x 6
38. Hex screw (M10 x 55) x 2
39. Coupling left/right pedal tube x 1/1
40. End piece x 2
41. Foam rubber grip x 2
42. Fastener for handlebars x 1.
43. Pulse cable x 2
44. Spring washer (Ø 8) x 8
45. Hex screw (M8 x 16) x 8
46. Handlebar post x 1
47. Guard x 1
48. Flat washer (Ø 12 x Ø 24) x 2
49. Handlebar post cover x 1
50. Power cord x 1
51. Long axle x 1
52. Flat washer (Ø 10 x Ø 20 x 2) x 4
53. Sensor cable x 1
54. Guard x 4
55. Guard x 2
56. Left/right crank arm x 1/1
57. Screw x 4
58. Spring washer (Ø 8 x Ø 25 x R 39) x 2
FIG. 1
ASSEMBLY
NOTE:
• Take out the machine and all the parts
from the packaging. Check the list to see
that no parts are missing.
32
• Make sure there is enough free space
around the machine for its assembly.
1. Screw the front foot (23) on the frame
(1) with the hex screws (21) and spring
washers (20), and screw the rear foot (3)
on the frame (1) with the hex screws (4)
and spring washers (58), as shown in the
diagram.
FIG. 2
2. Put the handlebar post guard (49) on the
handlebar post (46). Connect the power
cord (50) to the sensor cable (53) and fit
the handlebar post (46) on the frame (1)
with the hex screws (45), spring washers
(44) and flat washers (12). Move down
the handlebar post guard (49) to the
correct position.
FIG. 3
3. Put the pulse cable (43) through the
handlebar post (46) and the hole up in
the computer bracket. Lock the fastener
for the handlebars (42) at the handlebar
post (46) with the hex screws (45) and
flat washers (44).
FIG. 4
4. Fit the left/right tube arms (24L/R) on
the long axle (51) on the handlebar post
(46) with hex screw (10), spring washer
(11), flat washer (52), D-shaped washer
(9) and wave washers (35). Do not fully
tighten the screws until the assembly is
complete.
5. Fit the couplings for the left/right pedal
tubes (39L/R) on the left/right crank
arms (56L/R) with hex screw (10), spring
washer (11), D-shaped washer (9), flat
washer (52) and wave washers (35).
Do not fully tighten the screws until the
assembly is complete.
6. Fit the left/right tube arms (24L/R) and
left/right pedal brackets (15L/R) with cap
screw (18), flat washer (5), flat washer
(48) and nyloc nut (6).