Table of Contents
Advertisement
8-2. Adjustment of the home position
Mechanical home position is adjusted at the position shown on the figure. This position can be adjusted
finely within the range to show to the list shown below but it is impossible to move the position itself
(change of home position).
Presser plate
[Notice] The machine has a function that the motor memorizes the home position at the first home
position returning operation after the switch is turned on. Therefore, from the second home
position returning, it does not use the home position return sensor. Make sure to turn the power
switch off to change the mechanical home position.
To use the sensor from the send returning, press
[Home returning method since the second time returning] on the standard screen and set it ON.
[Notice] If the detector clearance becomes more than 1.5mm, the work holder stop position becomes
unstable, furthermore, if the clearance becomes far bigger than 1.5mm the work holder does not
stop and becomes out of control.
400
-X
-Y
+Y
+X
200
200
X-axis plus direction
X-axis Minus direction
Y-axis plus direction
Y-axis Minus direction
- 22 -
Sewing area
Mechanical
home position
10
5mm
5mm
0mm
5mm
→
→
Advertisement
Table of Contents
