3-3. Installation of the foot switch, and connection of the control cables
Connect the foot switch to the connector CON H. The foot switch is enclosed in the accessory box.
Control cable to connect to already be connected as shown on the figure below.
CON A
CON E
CON F1
CON F2
CON H
3-4. Installation of the thread stand
(1) Assemble the parts (No.1 to No.11 , and No.15) of the thread stand as shown on the figure.
(2) Fit the thread stand into the hole at the far right on the table stand with the nut (No.13) , the washer
(No.12) and the collar (No.14).
<9>
<15>
<6>
<5>
<4>
<3>
<7>
<8>
<10>
CON A: Operation panel
CON B
CON B: Power supply
CON C: Various solenoid DC power
CON C
CON D: Spindle motor
CON E: Various solenoid
CON D
CON F1: Detector
CON F2: Spindle encoder
CON G
CON G: X-Y spindle encoder
CON H: Foot switch
CON J
CON J: X-Y spindle stepping motor
<1>: Upper column pipe
<2>: Lower column pipe
<3>: Spool stand base (two stand bases)
<4>: Spool mat (two mats)
<5>: Spool holder (two holders)
<1>
<6>: Spool shaft (two shafts)
<7>: Spring washer (two washers)
<8>: Nut (four nuts)
<11>
<9>: Thread hunger
<10>: Spool holder
<11>: Column joint
<12>: Washer
<2>
<13>: Nut
<14>: Collar
<15>: Thread tension guide
<14>
<12>
<13>
- 5 -