Table of Contents
Advertisement
7-19. Adjustment of the X-Y mechanical home position
The mechanical home position (No.1) is fixed at the center of the sewing area as the factory default
setting. The machine can be moved within the area (No.2) covered with diagonal lines.
(1) After canceling the sewing area limit, change the mechanical home position.
(2) Press the
on the standard screen to open the MENU mode.
(3) Press the
(4) Select the
on the [Cancellation of sewing area limit] screen, and press the
(5) When turning the power off then, the setting of the sewing area limit is cancelled.
7-19-1. Adjustment of the X direction
(1) Turn the power switch off.
(2) Remove the covers on the top of the sewing machine bed.
(3) The mechanical home position of the X direction is the position where the detector (No.2) can detect
the edge of the detector plate X (No.1).
(4) For the adjustment of the X direction mechanical home position, loosen the detector plate set screws
(No.3) at the left and right side then, move the detector plate X in the arrow direction as shown on the
figure. Set the clearance between the detector plate X and the detector within the range of 1.0 to
1.5mm.
(5) Turn the power switch on. Press the home position return icon
home position.
(6) If the mechanical home position is not the desired position, carry out the same procedure (4) and (5)
again. In that case, turn the power switch off each time.
[Notice] The machine has a function that the motor memorizes the home position at the first home
position returning operation after the switch is turned on. Therefore, from the second home position
returning, it does not use the home position return sensor. Make sure to turn the power switch off to
change the mechanical home position.
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com
<2>
->
->
<1>
<1>: Home position as the factory default
<2>: Adjustable area
[Cancellation of sewing area limit] in order.
- 35 -
.
, and check the mechanical
Advertisement
Table of Contents
