5-5. Setting the bobbin
(1) Set a bobbin in the bobbin case.
(2) Raise the bobbin holding lever A of bobbin case
to set.
(3) Introduce the thread in the cut groove B of
bobbin case and pass through the thread hole C.
(4) Pull the thread and confirm the bobbin turns in
the counterclockwise direction. If it turns in
reverse direction, invert the bobbin.
5-6. Setting the bobbin case
(1) Open the hook cover.
(2) Bring the thread take up lever at the highest
position.
(3) Turn to left the hook holder arm under the
machine table.
[Notice] Pull the thread end about 3 cm
out of the bobbin case.
(4) Insert securely the bobbin case, from its head
first, into the hook.
(5) Turn to right the hook holder arm to lock the
bobbin case in position.
(6) Close the hook cover.
Turn direction
B
Bobbin case
Hook holder
arm
Bobbin case
- 10 -
C
Bobbin
A
Hook
Inner hook
holder