Table of Contents
Advertisement
5-5. Setting the bobbin
(1) Insert a full bobbin (No.2) into the bobbin case (No.1).
(2) Pull out the bobbin thread (No.3) from the slit (No.4) and pass the thread through the thread hole
(No.5). When the bobbin thread is pulled, the bobbin rotates in the arrow direction shown on the figure.
If the bobbin starts rotating to the opposite direction, turn the bobbin over and reset the bobbin.
<5>
5-6. Setting the bobbin case
(1) Pull the bobbin thread about 25 mm out of the thread hole of the bobbin case.
(2) Open the cylinder cover (No.1).
(3) Open the bobbin case latch (No.2) and hold it then, fit it securely in the shuttle hook (No.3).
<3>
<1>
From the library of Superior Sewing Machine & Supply LLC - www.supsew.com
<4>
<2>
<1>
<3>
25ｍm
- 24 -
<1>: Bobbin case
<2>: Bobbin
<3>: Thread
<4>: Bobbin case slit
<5>: Bobbin case thread hole
<1>: Cylinder cover
<2>: Bobbin case latch
<3>: Shuttle hook
<2>
Advertisement
Table of Contents
