Advertisement
Step 2.
Lift top frame of cradle, and
turn handle so that it lines up
with the plastic hinges.
Step 3.
Snap handle and hinges
together to lock.
Be sure
handle is locked into the
plastic hinges.
Step 4.
Place cradle in hanger.
Be sure handle notches are
seated in the hanger.
Step 5.
Place your child in the cradle.
Step 6.
Set the control switch between
the low and medium positions.
Your cradle will swing properly
only in the lower range.
Step 7.
Give cradle a push to start the
swinging motion.
Using the
Infant Carrier
Lift carrier in and out of swing.
Do not adjust
the handle while carrier is on
swing.
Different uses for infant carrier...
Cuddler
Carrier
...or as a Rocker.
Hanger
Notch
Feeder
7
Adjusting the Handle
To bring infant carrier handle
from resting position into posi-
tion for carrying or swinging,
first set the carrier down.
Then push down on center of
handle, and rotate the handle
forward until it clicks into the
locked position.
To return the handle to resting
position, first set the carrier
down. Then push down on
center of handle, and rotate the
handle backward until it clicks
into place.
NOTE: It is normal for the
handle to seem loose in the
resting position.
Using the Tray
Unlatch the tray by squeezing
the two latches under the tray
at the same time, and lift up
tray. Be careful not to let tray
hit your baby when lifting or
closing tray.
To latch tray, push down firmly.
Tray must be latched at all
times when baby is in the
swing.
Adjusting the Stand
To change recline of the carrier,
squeeze the adjustment wire
and move to desired position.
To adjust for rocking, move the
adjustment wire to the highest
position.
Do not
change recline with baby in
infant carrier.
Be aware that infant move-
ment or rocking may cause
the infant carrier to move on
a table.
Push down
on center
of handle
Push down
on center
of handle
8
Advertisement
